Home › Vehicle Interior › EXTERIOR › REAR BUMPER(for Steel Type Bumper)
RM27M0U _58 Vehicle Interior _049164 EXTERIOR _0234482 REAR BUMPER(for Steel Type Bumper) A

EXTERIOR  REAR BUMPER(for Steel Type Bumper)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

As the rear bumper cover is extremely heavy, the engine lifter may suddenly drop if the instructions listed in the repair manual are not followed. Therefore, always follow the instructions listed in the repair manual when performing this procedure.


PROCEDURE

Hide 82824X 1.REMOVE WIRING HARNESS CONNECTOR (w/ Towing Package)

a.
B355009

Disconnect the connector.


b.

Detach the 2 claws and remove the wiring harness connector.


Hide 82821A 2.REMOVE CONNECTOR COVER (w/o Towing Package)

HINT:

Use the same procedure described for the wiring harness connector.


Hide 3.REMOVE REAR BUMPER COVER

a.
B355010

Disconnect the 2 connectors and detach the clamp.


b.

w/ Towing Package:

i.

Using an engine lifter or equivalent, remove the 12 bolts and rear bumper cover.

B355012

NOTICE:
·

Using plate lift attachments or equivalent, set the rear bumper cover on a flat surface.

·

Be sure to perform the operation with 2 persons or more.

·

Be careful not to damage the rear bumper cover.





c.

w/o Towing Package:

i.

Using an engine lifter or equivalent, remove the 8 bolts and rear bumper cover.

B355011

NOTICE:
·

Using plate lift attachments or equivalent, set the rear bumper cover on a flat surface.

·

Be sure to perform the operation with 2 persons or more.

·

Be careful not to damage the rear bumper cover.