Use the same procedure for the RH and LH sides.
The procedures listed below are for the LH side.
75641D
1.REMOVE LOWER NO. 1 SIDE PANEL MOULDING LH
When removing the lower No. 1 side panel moulding LH, heat the vehicle body and lower No. 1 side panel moulding LH using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Lower No. 1 Side Panel Moulding LH | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body and lower No. 1 side panel moulding LH excessively.
for Regular Cab:
Using a heat light, heat the vehicle body and lower No. 1 side panel moulding LH.
Put protective tape around the lower No. 1 side panel moulding LH.
Using a moulding remover, detach the 2 clips and remove the double-sided tape to remove the lower No. 1 side panel moulding LH.
| *1 | Protective Tape |
| *2 | Double-sided Tape |
for Double Cab:
Using a heat light, heat the vehicle body and lower No. 1 side panel moulding LH.
Put protective tape around the lower No. 1 side panel moulding LH.
Using a moulding remover, detach the 2 clips and remove the double-sided tape to remove the lower No. 1 side panel moulding LH.
| *1 | Protective Tape |
| *2 | Double-sided Tape |
for CrewMax:
Using a heat light, heat the vehicle body and lower No. 1 side panel moulding LH.
Put protective tape around the lower No. 1 side panel moulding LH.
Using a moulding remover, detach the 2 clips and remove the double-sided tape to remove the lower No. 1 side panel moulding LH.
| *1 | Protective Tape |
| *2 | Double-sided Tape |
66246
2.REMOVE REAR BODY NO. 3 PROTECTOR LH
When removing the rear body No. 3 protector LH, heat the vehicle body and rear body No. 3 protector LH using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Rear Body No. 3 Protector LH | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body or rear body No. 3 protector LH excessively.
for Regular Cab:
Using a heat light, heat the vehicle body and rear body No. 3 protector LH.
Pull back an edge of the rear body No. 3 protector LH and pull it parallel to the vehicle body to remove it.
for Double Cab:
Using a heat light, heat the vehicle body and rear body No. 3 protector LH.
Pull back an edge of the rear body No. 3 protector LH and pull it parallel to the vehicle body to remove it.
for CrewMax:
Using a heat light, heat the vehicle body and rear body No. 3 protector LH.
Pull back an edge of the rear body No. 3 protector LH and pull it parallel to the vehicle body to remove it.