Home › Vehicle Interior › SLIDING ROOF › SLIDING ROOF SYSTEM
RM27M0U _58 Vehicle Interior _049166 SLIDING ROOF _0234506 SLIDING ROOF SYSTEM U

SLIDING ROOF  SLIDING ROOF SYSTEM  TERMINALS OF ECU  


SLIDING ROOF DRIVE GEAR (SLIDING ROOF ECU)


U151843E02
1.615,0.333 1.938,0.5 0.323,0.167 10 false W3

a.

Disconnect the W3 ECU connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbols) Wiring Color Terminal Description Condition Specified Condition
W3-1 (UP) - Body ground BR - Body ground Sliding roof switch signal TILT switch is pressed to up Below 1 Ω
W3-1 (UP) - Body ground BR - Body ground Sliding roof switch signal TILT switch is not pressed to up 10 kΩ or higher
W3-2 (DWN) - Body ground W - Body ground Sliding roof switch signal TILT switch is pressed to down Below 1 Ω
W3-2 (DWN) - Body ground W - Body ground Sliding roof switch signal TILT switch is not pressed to down 10 kΩ or higher
W3-6 (OPN) - Body ground BE - Body ground Sliding roof switch signal SLIDE switch is pressed to open Below 1 Ω
W3-6 (OPN) - Body ground BE - Body ground Sliding roof switch signal SLIDE switch is not pressed to open 10 kΩ or higher
W3-7 (CLS) - Body ground V - Body ground Sliding roof switch signal SLIDE switch is pressed to close Below 1 Ω
W3-7 (CLS) - Body ground V - Body ground Sliding roof switch signal SLIDE switch is not pressed to close 10 kΩ or higher
W3-8 (E) - Body ground W-B - Body ground Ground Always Below 1 Ω
W3-9 (IG) - Body ground SB - Body ground IG power supply Ignition switch ON 11 to 14 V
W3-9 (IG) - Body ground SB - Body ground IG power supply Ignition switch off Below 1 V
W3-10 (B) - Body ground L - Body ground +B power supply Always 11 to 14 V

If the result is not as specified, there may be a malfunction on the wire harness side.