Home › Vehicle Interior › SLIDING ROOF › SLIDING ROOF HOUSING(for CrewMax)
RM27M0U _58 Vehicle Interior _049166 SLIDING ROOF _0234507 SLIDING ROOF HOUSING(for CrewMax) A

SLIDING ROOF  SLIDING ROOF HOUSING(for CrewMax)  DISASSEMBLY  


PROCEDURE

Hide 63260A 1.REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

B170248

a.

Remove the 2 bolts, room light bracket and drive gear.


Hide 63306 2.REMOVE SUNSHADE TRIM SUB-ASSEMBLY

B170250E01
0.756,0.33 1.375,0.511 0.619,0.181 10 Rearward

a.

Remove the 2 screws.


b.

Detach the 4 claws and remove the sliding roof piece LH and RH.


c.

Slide and remove the trim.


Hide 63205A 3.REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

NOTICE:

Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.


a.
B170260

Detach the 4 claws and remove the 4 roof wind deflector panel guide clips.


b.
B171167

Using a screwdriver, detach the claw.

HINT:

Tape the screwdriver tip before use.



c.

Slide each roof wind deflector lifter link in the direction indicated by the arrow in the illustration to remove it.


d.
B170251

Using a screwdriver, detach the 2 claws then slide the rear roof drip channel rearward to remove it.

HINT:

Tape the screwdriver tip before use.



e.

Place matchmarks on the sliding roof drive cable sub-assembly and sliding roof housing sub-assembly.


f.
B172255

Hold down the window deflector.


g.
B170252

Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.

HINT:

Tape the screwdriver tip before use.



Hide 63246D 4.REMOVE REAR SLIDING ROOF HOUSING MOUNTING BRACKET LH

a.
B171166

Remove the 2 bolts and mounting bracket.


Hide 63245D 5.REMOVE REAR SLIDING ROOF HOUSING MOUNTING BRACKET RH

HINT:

Use the same procedures described for the LH side.