84862
1.INSPECT SLIDE ROOF MOTOR SWITCH
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 (UP) - 5 (E) | Tilt switch is pressed to up | Below 1 Ω |
| 1 (UP) - 5 (E) | Tilt switch is not pressed to up | 10 kΩ or higher |
| 2 (DOWN) - 5 (E) | Tilt switch is pressed to down | Below 1 Ω |
| 2 (DOWN) - 5 (E) | Tilt switch is not pressed to down | 10 kΩ or higher |
| 4 (OPN) - 5 (E) | Slide switch is pressed to open | Below 1 Ω |
| 4 (OPN) - 5 (E) | Slide switch is not pressed to open | 10 kΩ or higher |
| 3 (CLS) - 5 (E) | Slide switch is pressed to close | Below 1 Ω |
| 3 (CLS) - 5 (E) | Slide switch is not pressed to close | 10 kΩ or higher |
If the result is not as specified, replace the slide roof motor switch.
| *1 | Tilt Switch |
| *2 | Slide Switch |
| *a | Up |
| *b | Down |
| *c | Open |
| *d | Close |
| *e | Component without harness connected
(Slide Roof Motor Switch) |