Home › Vehicle Interior › SEAT › FRONT POWER SEAT CONTROL SYSTEM(w/o Memory) › from 2016.08
RM27M0U _58 Vehicle Interior _049136 SEAT _0234309 FRONT POWER SEAT CONTROL SYSTEM(w/o Memory) D

SEAT  FRONT POWER SEAT CONTROL SYSTEM(w/o Memory)  OPERATION CHECK  


CHECK FRONT POWER SEAT FUNCTION


B352968E02
4.292,1.406 4.729,0.708 4.729,0.708 4.99,0.708 false 3.885,1.74 4.479,2.094 4.479,2.094 4.74,2.094 false 3.479,2.979 3.938,3.438 3.938,3.438 4.198,3.438 false 2.688,1.792 2.167,1.448 2.167,1.448 1.896,1.448 false 3.073,1.708 2.729,0.865 2.729,0.865 2.469,0.865 false 5.063,0.625 6.25,0.802 1.188,0.177 10 false Reclining Function 4.792,2 6.458,2.177 1.667,0.177 10 false Lumbar Support Function 4.24,3.344 5.906,3.521 1.667,0.177 10 false Slide Function 0.75,1.375 1.885,1.573 1.135,0.198 10 false Vertical Function* 1.448,0.781 2.448,0.979 1,0.198 10 false Lifter Function* 0.063,3.5 1.729,3.677 1.667,0.177 10 false *: for Driver Side

a.

Check the basic functions.

i.

Operate the power seat switches and check to make sure each seat function works:

·

Slide

·

Front vertical (for Driver Side)

·

Lifter (for Driver Side)

·

Reclining

·

Lumbar support





CHECK POWER SEAT MOTOR ASSEMBLY (SLIDING, FRONT VERTICAL, LIFTER, RECLINING AND LUMBAR SUPPORT)


a.

Check the PTC operation inside the power seat motor.

HINT:

The PTC thermistor's resistance increases when the power seat switch is held down even after the power seat has been moved to the maximum in one direction. If the resistance increases beyond a specified level, current is cut to prevent a short circuit.


NOTICE:
·

The inspection should be performed with the seat installed in the vehicle.

·

Perform the 4 steps below for each power seat function.



i.

Choose a power seat function. Operate the power seat switch and move the seat as much as possible in one direction. Keep the seat in that position for approximately 60 seconds.


ii.

Operate the power seat switch again and continue to try to move the seat in the same direction as in the previous step. Measure the amount of time elapsed before current is automatically cut (the sound of the motor has stopped).

Standard:

4 to 90 seconds



iii.

After current has been cut, release the power seat switch and wait for approximately 60 seconds.


iv.

Operate the same power seat switch and move the seat in the opposite direction. Check that the motor operates.