Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
72526
1.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH
Raise the reclining adjuster release handle LH to reveal the claw.
Using a screwdriver, detach the claw and remove the reclining adjuster release handle LH.
Tape the screwdriver tip before use.
| *1 | Protective Tape |
71812D
2.REMOVE FRONT SEAT CUSHION SHIELD LH
Disconnect the 2 rubber bands.
Remove the 3 screws.
Detach the guide, clip and 2 claws as indicated by the arrows in the order shown in the illustration to remove the front seat cushion shield LH.
73240
3.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)
73230
4.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)
89178A
5.REMOVE SEAT POSITION AIRBAG SENSOR
71868A
6.REMOVE FRONT INNER NO. 1 SEAT CUSHION SHIELD LH
Remove the 2 screws.
Detach the guide in the direction indicated by the arrow shown in the illustration to remove the front inner No. 1 seat cushion shield LH.
7.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Detach the connector clamp and 3 wire harness clamps to disconnect the wire harness of the front seat airbag assembly LH.
| *1 | Connector Clamp |
| *2 | Wire Harness Clamp |
Remove the 4 bolts and separate type front seatback assembly.
71074S
8.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
Detach the hook.
Pull out the wire harness from the separate type front seatback cover.
Open the 2 fasteners.
Detach the 2 hooks.
Remove the 4 clips.
Slide each hook to detach them.
Pull out the 4 straps of the separate type front seatback cover from the separate type front seatback pad.
Detach the 6 fasteners to remove the separate type front seatback cover from the separate type front seatback pad.
| *1 | Fastener |
Remove the 2 hog rings.
Detach the 4 claws to remove the 2 front seat headrest supports.
Remove the separate type front seatback cover from the separate type front seatback pad.
71552S
9.REMOVE SEPARATE TYPE FRONT SEATBACK PAD
Remove the separate type front seatback pad from the front seatback frame sub-assembly LH.
73920A
10.REMOVE FRONT SEAT AIRBAG ASSEMBLY LH
72574
11.REMOVE RECLINING CONTROL LEVER LH
Remove the bolt and reclining control lever LH.
71013
12.REMOVE FRONT SEATBACK SPRING ASSEMBLY
Detach the 2 clips and 2 guides to remove the front seatback spring assembly.
71759B
13.REMOVE FRONT SEATBACK HOOK
Remove the 2 front seatback hooks from the front seatback spring assembly.
14.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
Detach the 12 hooks and remove the separate type front seat cushion cover with pad.
71072S
15.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Detach the 2 fasteners.
Remove the 10 hog rings and separate type front seat cushion cover.
| *1 | Fastener |
89952
16.REMOVE OCCUPANT CLASSIFICATION ECU (for Front Passenger Side)
82191
17.REMOVE FRONT SEAT CUSHION WIRE RH (for Front Passenger Side)
Disconnect the 4 connectors.
Detach the connector clamp and 5 wire harness clamps to remove the front seat cushion wire RH.
| *1 | Connector Clamp |
| *2 | Wire Harness Clamp |
71620S
18.REMOVE SEPARATE TYPE FRONT SEAT CUSHION SPRING ASSEMBLY
Detach the hook of the front side.
Detach the 4 hooks of the rear side to remove the separate type front seat cushion spring assembly.
71874
19.REMOVE FRONT LOWER SEAT CUSHION SHIELD LH
Detach the 2 claws to remove the front lower seat cushion shield LH.
71873
20.REMOVE FRONT LOWER SEAT CUSHION SHIELD RH
Use the same procedure described for the LH side.
72125A
21.REMOVE UPPER SEAT TRACK COVER
Detach the 2 claws to remove the upper seat track cover.
Use the same procedure for all upper seat track covers.
72125N
22.REMOVE UPPER NO. 4 SEAT TRACK COVER
Detach the 2 claws to remove the upper No. 4 seat track cover.
72125M
23.REMOVE UPPER NO. 3 SEAT TRACK COVER
Use the same procedure described for the upper No. 4 seat track cover.
24.REMOVE FRONT SEAT CUSHION SHIELD WIRE LH
Remove the 2 screws and front seat cushion shield wire LH.
25.REMOVE FRONT SEAT CUSHION SHIELD WIRE RH (for Front Passenger Side)
Use the same procedure described for the LH side.