1.INSTALL STUD BOLT
Using E7 and E8 "TORX" socket wrenches, install the stud bolts.
11117F
2.INSTALL NO. 2 STRAIGHT SCREW PLUG
Using a 14 mm hexagon wrench, install 2 new gaskets and the 2 straight screw plugs.
11117E
3.INSTALL NO. 1 STRAIGHT SCREW PLUG
Using a 10 mm hexagon wrench, install 6 new gaskets and the 6 straight screw plugs.
13734
4.INSTALL VALVE SPRING SEAT
Install the valve spring seats to the cylinder head.
13711A
5.INSTALL VALVE STEM OIL SEAL
Apply a light coat of engine oil to new oil seals.
Pay attention when installing the intake and exhaust oil seals. For example, installing the intake oil seal into the exhaust side or installing the exhaust oil seal into the intake side can cause installation problems later.
for Intake Side
The intake side valve stem oil seals is gray or black.
for Exhaust Side
The exhaust side valve stem oil seals is black or gray.
Using SST, push in the oil seals.
Failure to use SST will cause the seal to be damaged or improperly seated.
13711
6.INSTALL INTAKE VALVE
Apply plenty of engine oil to the tip area of the intake valve shown in the illustration.
Install the valve, compression spring and spring retainer to the cylinder head.
Install the same parts in the same combination to their original locations.
Install the inner compression spring to the wide end of the cylinder head sub-assembly.
Using SST and wooden blocks, compress the spring and install the valve spring retainer locks.
Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.
Do not damage the valve stem tip.
Be careful not to damage the retainer.
13715
7.INSTALL EXHAUST VALVE
Apply plenty of engine oil to the tip area of the exhaust valve shown in the illustration.
Install the valve, compression spring and spring retainer to the cylinder head.
Install the same parts in the same combination to their original locations.
Install the inner compression spring to the wide end of the cylinder head sub-assembly.
Using SST and wooden blocks, compress the spring and install the valve spring retainer locks.
Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.
Do not damage the valve stem tip.
Be careful not to damage the retainer.