Home › Vehicle Interior › EXTERIOR › REAR BUMPER(for Resin Type Bumper) › from 2016.08
RM27M0U _58 Vehicle Interior _049164 EXTERIOR _0234500 REAR BUMPER(for Resin Type Bumper) A

EXTERIOR  REAR BUMPER(for Resin Type Bumper)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

As the rear bumper cover is extremely heavy, the engine lifter may suddenly drop if the instructions listed in the repair manual are not followed. Therefore, always follow the instructions listed in the repair manual when performing this procedure.


HINT:

If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK

If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.


PROCEDURE

Hide 82824X 1.REMOVE WIRING HARNESS CONNECTOR (w/ Towing Package)

a.
B355009

Disconnect the connector.


b.

Detach the 2 claws and remove the wiring harness connector.


Hide 82821A 2.REMOVE CONNECTOR COVER (w/o Towing Package)

HINT:

Use the same procedure described for the wiring harness connector.


Hide 3.REMOVE REAR BUMPER COVER

a.
B355010

Disconnect the 2 connectors and detach the clamp.


b.

w/ Towing Package:

i.

Using an engine lifter or equivalent, remove the 12 bolts and rear bumper cover.

B355012

NOTICE:
·

Using plate lift attachments or equivalent, set the rear bumper cover on a flat surface.

·

Be sure to perform the operation with 2 persons or more.

·

Be careful not to damage the rear bumper cover.





c.

w/o Towing Package:

i.

Using an engine lifter or equivalent, remove the 8 bolts and rear bumper cover.

B355011

NOTICE:
·

Using plate lift attachments or equivalent, set the rear bumper cover on a flat surface.

·

Be sure to perform the operation with 2 persons or more.

·

Be careful not to damage the rear bumper cover.