|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part |
|
Toyota Genuine CVT Fluid FE |
33493C
1.INSTALL TRANSMISSION OIL COOLER ASSEMBLY
Coat 2 new O-rings with Toyota Genuine CVT fluid FE and install them to the transaxle housing.
Install the transmission oil cooler to the transaxle housing with the 3 bolts.
Be careful not to damage the O-rings.
16290F
2.CONNECT NO. 3 WATER BY-PASS HOSE ASSEMBLY
Connect the No. 3 water by-pass hose assembly to the transmission oil cooler and slide the hose clip to secure it.
16281N
3.CONNECT NO. 4 WATER BY-PASS HOSE
Connect the No. 4 water by-pass hose to the transmission oil cooler and slide the hose clip to secure it.
4.ADD ENGINE COOLANT
5.ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID
6.INSPECT FOR COOLANT LEAK
7.INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK
51442C
8.INSTALL ENGINE UNDER COVER LH
51410
9.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY