| ● | Non-reusable part | - | - |
1.REMOVE BACK DOOR OUTSIDE GARNISH
85143R
2.REMOVE REAR WIPER MOTOR GROMMET
76807
3.REMOVE REAR SPOILER SIDE PROTECTOR SUB-ASSEMBLY RH
68131
4.REMOVE BACK DOOR GLASS
|
|
| *a | When using a new Back Door Glass | *b | When reusing the Back Door Glass |
| *c | Matchmark | - | - |
Apply protective tape to the area around the installation position of the back door glass on the vehicle body to prevent it from being scratched as shown in the illustration.
When reusing the back door glass, place matchmarks on the back door glass and vehicle body at the locations indicated in the illustration.
Disconnect each connector.
w/ Digital Audio Broadcasting Antenna:
Disconnect the connector.
| *a | Suction Cup | - | - |
Install the suction cups to the back door glass.
| *1 | Back Window Glass Clip LH | *2 | Back Window Glass Clip RH |
| *a | Piano Wire | - | - |
Cut off the adhesive by the below procedure.
1. Pass a piano wire between the vehicle body and back door glass from the interior.
2. Tie both wire ends to wooden blocks or similar objects that can serve as handles.
3. Cut off the adhesive by pulling the piano wire around the back door glass.
Using suction cups, disengage the back window glass clip LH and back window glass clip RH to remove the back door glass.
Be careful not to drop the back door glass.
Leave as much adhesive on the vehicle body as possible when removing the back door glass.
64813B
5.REMOVE BACK WINDOW GLASS ADHESIVE DAM
When reusing the back door glass:
| *a | Back Side of Back Door Glass | - | - |
Using a scraper, remove the back window glass adhesive dam.
Be careful not to damage the back door glass.
Be sure to replace the back window glass adhesive dam with a new one.
75575D
6.REMOVE BACK WINDOW LOWER MOULDING
When reusing the back door glass:
| *a | Back Side of Back Door Glass | - | - |
Using a scraper, remove the back window lower moulding.
Be careful not to damage the back door glass sub-assembly.
Be sure to replace the back window lower moulding with a new one.
75574B
7.REMOVE BACK WINDOW OUTSIDE MOULDING LH
When reusing the back door glass:
| *a | Back Side of Back Door Glass | - | - |
Using a scraper, remove the back window outside moulding LH.
Be careful not to damage the back door glass.
Be sure to replace the back window outside moulding LH with a new one.
75573C
8.REMOVE BACK WINDOW OUTSIDE MOULDING RH
Use the same procedure as for the LH side.
64828B
9.REMOVE BACK WINDOW GLASS CLIP LH
When reusing the back door glass:
| *a | Back Side of Back Door Glass | - | - |
Using a scraper, remove the back window glass clip LH.
Be careful not to damage the back door glass.
Be sure to replace the back window glass clip LH with a new one.
64827B
10.REMOVE BACK WINDOW GLASS CLIP RH
Use the same procedure as for the LH side.