| *A | w/ Panoramic View Monitor System | - | - |
| *1 | BODY | *2 | OUTER MIRROR RETRACTOR |
| ● | Non-reusable part | - | - |
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
3.REMOVE OUTER MIRROR LOWER COVER
w/o Panoramic View Monitor System:
w/ Panoramic View Monitor System:
86790F
4.REMOVE SIDE TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)
81740
5.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY
6.REMOVE GASKET
| *a | Cut here | - | - |
Remove the vinyl tape.
Cut the wire harness at the position as shown in the illustration.
Remove the 3 stud bolts.
Disengage the guides to remove the gasket.
87948
7.REMOVE OUTER MIRROR HOLE COVER
Using a screwdriver with its tip wrapped in protective tape, disengage the claws and guides to remove the outer mirror hole cover.
8.REMOVE BASE SUB-ASSEMBLY
Using a T25 "TORX" socket wrench, remove the 3 screws.
Remove the base sub-assembly with the base seal and upper base cover.
9.REMOVE BASE SEAL
10.REMOVE UPPER BASE COVER
11.REMOVE POWER UNIT ASSEMBLY
12.REMOVE OUTER MIRROR RETRACTOR SUB-ASSEMBLY
13.REMOVE WIRE HARNESS