| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 8 | WINDSHIELD WIPER MOTOR ASSEMBLY | 85110 | ( )
|
- | - |
| *1 | WINDSHIELD WIPER LINK ASSEMBLY | - | - |
85292B
1.REMOVE FRONT WIPER ARM HEAD CAP
|
Remove in this Direction | - | - |
Using a screwdriver with its tip wrapped with protective tape, disengage the claws to remove the front wiper arm head cap.
Use the same procedure for the RH side and LH side.
2.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
3.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
53867
4.REMOVE FRONT FENDER TO COWL SIDE SEAL LH
|
Remove in this Direction | - | - |
53866
5.REMOVE FRONT FENDER TO COWL SIDE SEAL RH
Use the same procedure as for the LH side.
55708
6.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
|
Remove in this Direction | - | - |
7.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
|
|
|
Remove in this Direction | - | - |
85110
8.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
| *1 | No. 1 Windshield Wiper Link Rod | - | - |
| *a | Pivot of Windshield Wiper Motor Assembly | - | - |
Using a screwdriver with its tip wrapped in protective tape, separate the No. 1 windshield wiper link rod from the pivot of the windshield wiper motor assembly as shown in the illustration.
Using a T30 "TORX" socket wrench, remove the 2 screws.
Disengage the guides to remove the windshield wiper motor assembly.