Home › Steering › STEERING COLUMN › STEERING SYSTEM
RM3700E _55 Steering _093030 STEERING COLUMN _0438543 STEERING SYSTEM N

STEERING COLUMN  STEERING SYSTEM  ADJUSTMENT  


PROCEDURE

Hide 1.ADJUST STEERING CENTER

HINT:

This is the adjustment procedure for when the steering is off center.


a.

Check if the steering wheel is off center.

i.
C433450C02
1.677,0.625 1.021,0.281 1.021,0.281 1.74,0.813 true 0.833,0.198 1.146,0.396 0.313,0.198 10 false *a
*a Masking Tape


Apply masking tape to the top center of the steering wheel and upper steering column cover.


ii.
C433451C02
1.698,0.635 2.979,0.781 2.979,0.781 1.688,0.885 true 3.031,0.677 3.344,0.875 0.313,0.198 10 false *a
*a Marked Line


Drive the vehicle in a straight line for 100 m (328 ft.) at a constant speed of 56 km/h (35 mph), and hold the steering wheel to maintain the course.


iii.

Draw a line on the masking tape as shown in the illustration.


iv.
C433452C02
0.958,0.823 1.656,0.823 true 0.792,0.74 1.104,0.938 0.313,0.198 10 false *a
*a Marked Line


Turn the steering wheel to the center position.

HINT:

Look at the upper surface of the steering wheel, steering spoke and SRS airbag line to find the center position.



v.

Draw a new line on the masking tape on the steering wheel as shown in the illustration.


vi.

Measure the distance between the 2 lines on the masking tape on the steering wheel.


vii.

Convert the measured distance to steering angle.

HINT:
·

Measured distance of 1 mm (0.0394 in.) = Steering angle of approximately 1 degree.

·

Make a note of the steering angle.





b.

Adjust the steering angle.

i.
C433453C02
1.542,1.063 1.26,0.646 1.26,0.646 1.771,1.063 true 1.083,0.542 1.396,0.74 0.313,0.198 10 false *a
*a Matchmark


Draw a line on the RH and LH tie rod ends and rack ends where it can be easily seen.


ii.
C433454

Remove the RH and LH steering rack boot clips from the steering rack boots.


iii.

Loosen the RH and LH lock nuts.


iv.

Turn the RH and LH rack ends by the same amount (but in different directions) according to the steering angle.

HINT:

One 360 degree turn of the rack ends (1.0 mm (0.0394 in.)) horizontal movement equals 12 degrees of steering angle.



v.

Tighten the RH and LH lock nuts to the specified torque.

Click hereSteering>STEERING GEAR / LINKAGE>STEERING GEAR>INSTALLATION


vi.

Install the RH and LH steering rack boot clips.


vii.

Perform calibration of torque sensor zero point.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION