| *1 | STEERING GEAR ASSEMBLY | - | - |
| ● | Non-reusable part |
|
Lithium soap base glycol grease |
45536
1.INSTALL NO. 2 STEERING RACK BOOT
|
Lithium Soap Base Glycol Grease | - | - |
Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot.
Install the No. 2 steering rack boot to the groove on the rack housing.
Be careful not to damage or twist the No. 2 steering rack boot.
Make sure that the No. 2 steering rack boot is free of rust and foreign matter.
Do not touch the inside of the rack boot or rack bar when performing installation.
45535
2.INSTALL NO. 1 STEERING RACK BOOT
45536A
3.INSTALL NO. 2 STEERING RACK BOOT CLAMP
Temporarily install a new No. 2 steering rack boot clamp to the No. 2 steering rack boot.
Do not damage the No. 2 steering rack boot.
Using SST, install a new steering rack boot retainer as shown in the illustration.
3.0 mm (0.118 in.) or less
Be careful not to damage or twist the No. 2 steering rack boot.
45535D
4.INSTALL NO. 1 STEERING RACK BOOT CLAMP
45535B
5.INSTALL STEERING RACK BOOT CLIP (for LH Side)
Using pliers, install the steering rack boot clip.
45535B
6.INSTALL STEERING RACK BOOT CLIP (for RH Side)
45510
7.INSPECT STEERING GEAR ASSEMBLY
Using SST, rotate the pinion shaft to see if both the left and the right steering rack boots expand and contract smoothly.
If the left and right steering rack boots do not expand and contract smoothly, use new steering rack boot clamps and reinstall the steering rack boots.