The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear bumper assembly removal/installation are shown below.
52592
1.REMOVE REAR BUMPER SIDE SEAL LH
52591
2.REMOVE REAR BUMPER SIDE SEAL RH
Use the same procedure as for the LH side.
75606B
3.SEPARATE QUATER OUTSIDE MOULDING SUB-ASSEMBLY LH
|
Place Hand Here |
|
Remove in this Direction |
Apply protective tape around the quarter outside moulding sub-assembly LH.
Remove the screw.
Disengage the claws by pushing the area indicated by the arrow in the illustration with a finger.
To avoid damaging the claws, do not forcibly pull the quarter outside moulding sub-assembly LH.
Disengage the clips to separate the quarter outside moulding sub-assembly LH from the rear bumper assembly.
75605B
4.SEPARATE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
5.REMOVE REAR BUMPER ASSEMBLY
Apply protective tape around the rear bumper assembly.
Remove the 2 rear bumper cushions.
Remove the 3 clips.
| *A | w/ Wire Harness | - | - |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the claws as shown in the illustration.
Disengage the claws to remove the rear bumper assembly as shown in the illustration.
w/ Wire Harness:
1. Disconnect the connector.