| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | NO. 1 FRONT WHEEL OPENING EXTENSION PAD | 53851G | ( )
|
- | - |
| 2 | FRONT WHEEL OPENING EXTENSION PAD | 53851D | ( )
|
- | - |
| 3 | FRONT FENDER LINER RETAINER | 53879A | - | - | - |
| *1 | FRONT FENDER MOULDING | - | - |
| ● | Non-reusable part | - | - |
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
53851G
1.INSTALL NO.1 FRONT WHEEL OPENING EXTENSION PAD
|
|
| Item | Temperature |
|---|---|
| Front Fender Moulding | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the front fender moulding excessively.
| *a | Location Line | - | - |
Clean the front fender moulding.
1. Using a heat light, heat the front fender moulding surface.
2. Remove any remaining double-sided tape from the front fender moulding.
3. Wipe off any tape adhesive residue with cleaner.
Installing the No. 1 front wheel opening extension pad with some double-sided tape remaining may cause poor adhesion. Perform this procedure until the tape is sufficiently removed.
Make sure to use a cloth when removing. Using a screwdriver, etc., may cause damage and poor adhesion.
Install a new No. 1 front wheel opening extension pad.
1. Using a heat light, heat the front fender moulding.
2. Remove the release paper from the No. 1 front wheel opening extension pad.
After removing the release paper, keep the exposed adhesive free from foreign matter.
3. Install the No. 1 front wheel opening extension pad as shown in the illustration.
Make sure that the end of the No. 1 front wheel opening extension pad is between the location lines.
Press the No. 1 front wheel opening extension pad firmly to install it.
53851D
2.INSTALL FRONT WHEEL OPENING EXTENSION PAD
|
|
| Item | Temperature |
|---|---|
| Front Fender Moulding | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the front fender moulding excessively.
| *a | Location Line | - | - |
Clean the front fender moulding.
1. Using a heat light, heat the front fender moulding surface.
2. Remove any remaining double-sided tape from the front fender moulding.
3. Wipe off any tape adhesive residue with cleaner.
Installing the front wheel opening extension pad with some double-sided tape remaining may cause poor adhesion. Perform this procedure until the tape is sufficiently removed.
Make sure to use a cloth when removing. Using a screwdriver, etc., may cause damage and poor adhesion.
Install a new front wheel opening extension pad.
1. Using a heat light, heat the front fender moulding.
2. Remove the release paper from the front wheel opening extension pad.
After removing the release paper, keep the exposed adhesive free from foreign matter.
3. Install the front wheel opening extension pad as shown in the illustration.
Make sure that the end of the front wheel opening extension pad is between the location lines.
Press the front wheel opening extension pad firmly to install it.
53879A
3.INSTALL FRONT FENDER LINER RETAINER