Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › WHEEL OPENING MOULDING (for Rear) › 2020.08–2021.07
RM3700E _59 Vehicle Exterior _093282 EXTERIOR PANELS / TRIM _0440184 WHEEL OPENING MOULDING(for Rear) A

EXTERIOR PANELS / TRIM  WHEEL OPENING MOULDING(for Rear)  REASSEMBLY  


CAUTION / NOTICE / HINT

COMPONENTS (REASSEMBLY)
B590993N02
3.677,0.271 3.958,0.271 false 5,1.24 5.385,1.24 false 4.438,0.115 4.719,0.469 0.281,0.354 18 false 1 4.26,0.188 4.417,0.479 0.156,0.292 10 false ● 5.438,1.167 5.677,1.396 0.24,0.229 10 false *1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 BODY OUTSIDE MOULDING PAD 75696A (Click here) - -

*1 QUARTER OUTSIDE MOULDING - -
● Non-reusable part - -

CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 75696A 1.INSTALL BODY OUTSIDE MOULDING PAD

Z101186

NOTICE:

When installing a new body outside moulding pad, heat the quarter outside moulding using a heat light.



Standard:
Item Temperature
Quarter Outside Moulding 20 to 30°C (68 to 86°F)


CAUTION:
E306500C23
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


·

Do not touch the heat light and heated parts.

·

Touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



NOTICE:

Do not heat the quarter outside moulding excessively.


a.
B590994N02
0.573,0.219 0.854,0.573 0.281,0.354 18 false i 4.198,0.094 4.479,0.448 0.281,0.354 18 false ii

i.

Clean the quarter outside moulding.

1. Using a heat light, heat the quarter outside moulding surface.

2. Remove any remaining double-sided tape from the quarter outside moulding.

3. Wipe off any tape adhesive residue with cleaner.

NOTICE:
·

Installing the body outside moulding pad with some double-sided tape remaining may cause poor adhesion. Perform this procedure until the tape is sufficiently removed.

·

Make sure to use a cloth when removing. Using a screwdriver, etc., may cause damage and poor adhesion.




ii.

Install a new body outside moulding pad.

1. Using a heat light, heat the quarter outside moulding.

2. Remove the release paper from the body outside moulding pad.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.


3. Install the body outside moulding pad as shown in the illustration.

HINT:

Press the body outside moulding pad firmly to install it.