MALFUNCTION DESCRIPTION
The hybrid vehicle control ECU (main CPU) monitors the battery ECU assembly.
The cause of this malfunction may be the following:
Battery ECU assembly malfunction
The hybrid vehicle control ECU (main CPU) monitors the battery ECU assembly and stores this DTC when it detects a malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate | DTC Output from | Priority |
|---|---|---|---|---|---|---|---|
| P0A1F94 | Hybrid/EV Battery Energy Control Module Unexpected Operation | The battery ECU assembly value received by the hybrid vehicle control ECU (main CPU) exceeds the threshold for a certain period of time.
(1 trip detection logic) |
Battery ECU assembly | Comes on | Master Warning:
Comes on |
Hybrid Control | A |
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>UTILITY
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the ignition switch off and wait for 2 minutes or more.
Turn the ignition switch to ON (READY) and wait for 10 seconds or more.
Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.
Check the DTC judgment result.
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE, perform driving pattern again.
Pre-procedure1
None.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| P0A1F94 and other DTCs are output | A |
| Only P0A1F94 is output | B |
| None of the above conditions are met | C |
Post-procedure1
Turn the ignition switch off.
A
B
C
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING