Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID BATTERY SYSTEM
RM3700E _51 Engine / Hybrid System _093506 HYBRID / BATTERY CONTROL _0441185 HYBRID BATTERY SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID BATTERY SYSTEM  P1AFD1C  Flying Capacitor/Internal Control Module Hybrid/EV Battery Monitor Voltage Out of Range  


DESCRIPTION

The battery ECU assembly monitors the HV battery voltage. If the battery ECU assembly detects a malfunction of its internal voltage detection circuits, it will store this DTC.

HINT:

If this DTC is output, it will be necessary to replace the battery ECU assembly.


DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate DTC Output from Priority
P1AFD1C Flying Capacitor/Internal Control Module Hybrid/EV Battery Monitor Voltage Out of Range Both of the following conditions are met:
The battery ECU assembly detects a malfunction of its internal voltage detection circuits.
The difference between the total voltage of all battery cells and the stack voltage is large.
(1 trip detection logic)
Battery ECU assembly Comes on Master Warning:
Comes on
HV Battery A

Related Data List
DTC No. Data List
P1AFD1C
·

Hybrid/EV Battery Cell 1 to 48 Voltage

·

Hybrid/EV Battery Voltage



CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>UTILITY


1.

Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

2.

Turn the ignition switch off and wait for 2 minutes or more.

3.

Turn the ignition switch to ON and wait for 10 seconds or more.

4.

Enter the following menus: Powertrain / HV Battery / Utility / All Readiness.

5.

Check the DTC judgment result.

HINT:
·

If the judgment result shows NORMAL, the system is normal.

·

If the judgment result shows ABNORMAL, the system has a malfunction.

·

If the judgment result shows INCOMPLETE or N/A, perform driving pattern again.




PROCEDURE

1.REPLACE BATTERY ECU ASSEMBLY

NEXT

COMPLETED