Home › Drivetrain › K320 (MULTIDRIVE / CVT) › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM
RM3700E _52 Drivetrain _092906 K320 MULTIDRIVE / CVT _0441241 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM J

K320 MULTIDRIVE / CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  ECU Power Source Circuit  


DESCRIPTION

When the ignition switch is turned to ON, battery voltage is applied to terminal MREL of the ECM through the coil of the EFI-MAIN NO. 1 relay. This causes the EFI-MAIN NO. 1 relay to close, which supplies power to terminal +B of the TCM.

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following procedure.

·

Perform registration and/or initialization when parts related to the continuously variable transaxle system are replaced.

Click hereDrivetrain>K320 (MULTIDRIVE / CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>PRECAUTION



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TCM - BODY GROUND)
a.

Disconnect the TCM connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D71)Location & Routing

Click Connector(D71)Engine Compartment>Engine Wire>Transmission Control ECU

D71-2 (E1) - Body ground Always Below 1 Ω



c.

Connect the TCM connector.


Result:
Proceed to
OK
NG



OK

2.INSPECT ECU TERMINAL VOLTAGE (+B TERMINAL)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT ECU TERMINAL VOLTAGE (+B TERMINAL)
a.

Disconnect the TCM connector.


b.

Turn the ignition switch to ON.


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition

Click Location & Routing(D71)Location & Routing

Click Connector(D71)Engine Compartment>Engine Wire>Transmission Control ECU

D71-1 (+B) - Body ground Ignition switch ON 11 to 14 V



d.

Turn the ignition switch off.


e.

Connect the TCM connector.


Result:
Proceed to
OK
NG



OK

NG

3.CHECK HARNESS AND CONNECTOR (TCM - EFI-MAIN NO. 1 RELAY)
3.CHECK HARNESS AND CONNECTOR (TCM - EFI-MAIN NO. 1 RELAY)
a.

Remove the EFI-MAIN NO. 1 relay from the No. 1 engine room relay block and No. 1 junction block assembly.


b.

Disconnect the TCM connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D71)Location & Routing

Click Connector(D71)Engine Compartment>Engine Wire>Transmission Control ECU

D71-1 (+B) - 3 (EFI-MAIN NO. 1 Relay) Always Below 1 Ω
D71-1 (+B) or 3 (EFI-MAIN NO. 1 Relay) - Body ground Always 10 kΩ or higher



d.

Connect the TCM connector.


e.

Install the EFI-MAIN NO. 1 relay to the No. 1 engine room relay block and No. 1 junction block assembly.


Result:
Proceed to
OK
NG



OK

GO TO ECM POWER SOURCE CIRCUIT (ENGINE CONTROL SYSTEM / SFI SYSTEM)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR