The No. 1 power back door control switch signal is sent to the multiplex network door ECU.
If the power back door does not operate using the No. 1 power back door control switch, a No. 1 power back door control switch circuit malfunction is a possible cause.
If the replacement, removal and installation of the multiplex network door ECU or disconnection of the connectors of the multiplex network door ECU has been performed, initialize the power back door system.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>INITIALIZATION
Check that the power back door function on the multi-information display in the combination meter assembly is set to ON.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>CUSTOMIZE PARAMETERS
| Result | Proceed to |
|---|---|
| Power back door function on the multi-information display in the combination meter assembly is set to ON (power back door system operation is permitted) | A |
| Power back door function on the multi-information display in the combination meter assembly is set to OFF (power back door system operation is prohibited) | B |
A
B
Check the power back door system condition.
| Result | Proceed to |
|---|---|
| The malfunction symptom reproduces | A |
| The malfunction symptom does not reproduce | B |
A
B
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>Power Back Door cannot be Operated Frequently
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| PBD Close Switch | No. 1 power back door control switch signal | ON or OFF | ON: No. 1 power back door control switch pushed
OFF: No. 1 power back door control switch not pushed |
- |
| Tester Display |
|---|
| PBD Close Switch |
The No. 1 power back door control switch functions as specified in the normal condition column.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR CONTROL SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the Y21 No. 1 power back door control switch connector.
Disconnect the Y30 multiplex network door ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(Y21,Y30)Location & Routingewd_type=routing;type=c,c;code=Y21,Y30 Click Connector(Y21)Body>No. 2 Back Door Wire>No. 1 Power Back Door Control Switchewd_type=component;type=c;code=Y21;pinno=5,2 Click Connector(Y30)Body>No. 2 Back Door Wire>Multiplex Network Door ECUewd_type=component;type=c;code=Y30;pinno=14 |
||
| Y21-5 (CLS) - Y30-14 (BDDN) | Always | Below 1 Ω |
| Y21-2 (E) - Body ground | Always | Below 1 Ω |
| Y21-5 (CLS) or Y30-14 (BDDN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG