| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT STABILIZER BAR | 48811 | ( )
|
- | - |
| 2 | FRONT STABILIZER LINK ASSEMBLY LH | 48810 | ( )
|
- | - |
| 3 | FRONT STABILIZER LINK ASSEMBLY RH | 48820B | ( )
|
- | - |
| 4 | STEERING LINK ASSEMBLY | - | - | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | - | - |
48811
1.INSTALL FRONT STABILIZER BAR
| *a | Identification Mark | - | - |
|
Front of the Vehicle | - | - |
Set the front stabilizer bar to the front suspension crossmember sub-assembly.
Make sure that the identification mark is positioned on the right side of the vehicle.
Install the front stabilizer bar to the front suspension crossmember sub-assembly with the 4 bolts.
Temporarily tighten the 4 bolts in order of (B) and (A) and then fully tighten the 2 bolts in the order of (B) and (A).
48810
2.INSTALL FRONT STABILIZER LINK ASSEMBLY LH
|
|
48820B
3.INSTALL FRONT STABILIZER LINK ASSEMBLY RH
4.INSTALL STEERING LINK ASSEMBLY