| *A | for 2WD | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear shock absorber assembly removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE REAR WHEEL
64715C
2.REMOVE DECK SIDE TRIM COVER
48597A
3.REMOVE REAR SHOCK ABSORBER CUSHION RETAINER
| *A | for 2WD | *B | for AWD |
| *a | Turn | *b | Hold |
for 2WD:
Support the spring seat of the rear axle beam assembly using a jack and wooden block.
Do not jack up the rear axle beam assembly too high as the vehicle may fall.
When jacking up the rear axle beam assembly, be sure to jack it up slowly.
Make sure to perform this operation with the vehicle kept as low as possible.
Keep supporting the rear axle beam assembly with a jack until the installation of the rear shock absorber assembly is completed.
for AWD:
Support the spring seat of the rear No. 1 suspension arm assembly using a jack and wooden block.
Do not jack up the rear axle beam assembly too high as the vehicle may fall.
When jacking up the rear No. 1 suspension arm assembly, be sure to jack it up slowly.
Make sure to perform this operation with the vehicle kept as low as possible.
Keep supporting the rear No. 1 suspension arm assembly with a jack until the installation of the rear shock absorber assembly is completed.
Using a 5 mm hexagon socket wrench, secure the rear shock absorber assembly rod and remove the nut using a wrench.
Remove the rear shock absorber cushion retainer.
48755
4.REMOVE REAR SUSPENSION SUPPORT
48540
5.REMOVE REAR SHOCK ABSORBER ASSEMBLY
for 2WD:
Remove the bolt while keeping the nut from rotating and remove the rear shock absorber assembly.
Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.
for AWD:
Remove the bolt and remove the rear shock absorber assembly.
48760B
6.REMOVE REAR SUSPENSION SUPPORT ASSEMBLY