This DTC is stored if the transponder key ECU assembly does not detect that the unlock warning switch assembly is on even when the ignition switch is ON.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|
| B2780 | Push Switch / Key Unlock Warning Switch Malfunction | The unlock warning switch assembly is not detected as being on when the ignition switch is ON (1 trip detection logic*). | ·
Wire harness or connector ·
Unlock warning switch assembly ·
Transponder key ECU assembly |
Immobiliser | A | DTC Output Confirmation Operation:
Insert the door control transmitter assembly into the ignition key cylinder. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Hybrid control system cannot be started | - |
| DTC No. | Data List and Active Test |
|---|---|
| B2780 | Key SW |
If the transponder key ECU assembly is replaced, refer to Service Bulletin.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
OK
NG
Pre-procedure1
Disconnect the H74 transponder key ECU assembly connector.
Disconnect the H55 unlock warning switch assembly connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H55,H74)Location & Routingewd_type=routing;type=c,c;code=H55,H74 Click Connector(H55)Instrument Panel>Instrument Panel Wire / Speaker Wire>Un-Lock Warning Switch Assemblyewd_type=component;type=c;code=H55;pinno=1,2 Click Connector(H74)Instrument Panel>Instrument Panel Wire / Speaker Wire>Transponder Key ECU Assemblyewd_type=component;type=c;code=H74;pinno=5 |
||
| H55-1 (UN+) - H74-5 (KSW) | Always | Below 1 Ω |
| H55-2 (UN-) - Body ground | Always | Below 1 Ω |
| H55-1 (UN+) or H74-5 (KSW) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG