Home › Engine / Hybrid System › M15A-FKS (ENGINE CONTROL) › IGNITION COIL AND SPARK PLUG
RM3700E _51 Engine / Hybrid System _093766 M15A-FKS ENGINE CONTROL _0442025 IGNITION COIL AND SPARK PLUG A

M15A-FKS ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
A459210N01
4.031,1.792 4.448,1.792 false 3.854,2.844 4.458,2.844 false 4.917,2.719 5.198,3.073 0.281,0.354 18 false 2 4.906,1.646 5.188,2 0.281,0.354 18 false 1 4.25,0.802 4.531,1.156 0.281,0.354 10 false x3 3.865,2.906 4.146,3.26 0.281,0.354 10 false x3 4.021,2.167 4.302,2.521 0.281,0.354 10 false x3

Procedure Part Name Code
Z101186

Z101188

Z101187

1 IGNITION COIL ASSEMBLY 19500 (Click here) - -
2 SPARK PLUG 19100P (Click here) - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ignition coil assembly or spark plug removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of ignition coil assembly

·

Replacement of spark plug


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 19500 1.REMOVE IGNITION COIL ASSEMBLY

a.
A458051N01
0.594,0.156 1.969,0.51 1.375,0.354 18 false i, ii

i.

Disconnect the 3 ignition coil assembly connectors.


ii.

Using an 8 mm socket wrench, remove the 3 bolts and 3 ignition coil assemblies from the cylinder head cover sub-assembly.

NOTICE:

If an ignition coil assembly has been struck or dropped, replace it.




Hide 19100P 2.REMOVE SPARK PLUG

Z101186

Click here(Click here)