Home › Engine / Hybrid System › M15A-FKS (ENGINE CONTROL) › KNOCK SENSOR
RM3700E _51 Engine / Hybrid System _093766 M15A-FKS ENGINE CONTROL _0442027 KNOCK SENSOR A

M15A-FKS ENGINE CONTROL  KNOCK SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
A459212N01
5.313,2.531 5.313,2.188 false 5.115,4.271 5.115,3.99 false 5.24,2.563 5.521,2.917 0.281,0.354 18 false 1 5.042,4.271 5.323,4.625 0.281,0.354 18 false 2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 INTAKE MANIFOLD 17111 - - -
2 KNOCK SENSOR 89615 (Click here) - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the knock sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly

·

Air leaks from intake system

·

Replacement of knock control sensor


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 89615 2.REMOVE KNOCK SENSOR

Z101186

NOTICE:

If the knock sensor has been struck or dropped, replace it.



a.
A458055