|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
22030
1.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY
Install a new throttle body gasket to the intake manifold with the protrusion of the throttle body gasket oriented as shown in the illustration.
Using an 8 mm socket wrench, install the throttle body with motor assembly to the intake manifold with the 3 bolts.
If the throttle body with motor assembly has been struck or dropped, replace it.
Connect the throttle body with motor assembly connector.
16296
2.INSTALL NO. 8 WATER BY-PASS HOSE
16282
3.INSTALL NO. 5 WATER BY-PASS HOSE
17881
4.INSTALL NO. 1 AIR CLEANER HOSE
| *a | Top of Vehicle | *b | Front of Vehicle |
Install the No. 1 air cleaner hose to the throttle body with motor assembly and tighten the hose clamp.
Align the cutout of the air cleaner hose with the protrusion of the throttle body with motor assembly as shown in the illustration.
12262
5.INSTALL NO. 2 VENTILATION HOSE
6.ADD ENGINE COOLANT
7.INSPECT FOR COOLANT LEAK
51410
8.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
9.PERFORM INITIALIZATION
Be sure to perform this procedure after removing and reinstalling the throttle body with motor assembly or any throttle body with motor assembly components.
Perform the following procedure after replacing the throttle body with motor assembly or any throttle body with motor assembly components. The following procedure should also be performed if the throttle body with motor assembly is cleaned.
Connect the GTS to the DLC3.
Turn the ignition switch on (IG).
Turn the GTS on.
Clear the DTCs.
Perform "Inspection After Repair".
Click hereEngine / Hybrid System>M15A-FXE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range with the A/C switch off.
950 to 1050 rpm
Be sure to perform this step with all accessories off.
Make sure that the shift lever is in P or N.
Enter the following menus: Powertrain / Engine / Data List / Throttle Position Sensor No.1 Voltage %.
| Tester Display |
|---|
| Throttle Position Sensor No.1 Voltage % |
According to the display on the GTS, read the Data List while fully depressing the accelerator pedal and check that the value is 60% or higher.
Perform a road test and confirm that there are no abnormalities.