Home › Engine / Hybrid System › M15A-FXE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM3700E _51 Engine / Hybrid System _093768 M15A-FXE ENGINE CONTROL _0442039 CRANKSHAFT POSITION SENSOR A

M15A-FXE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
A459226N01
1.438,1.594 1.656,1.594 1.656,1.594 1.917,1.26 false 1.792,4.063 2.125,4.063 false 2.156,1.313 2.021,0.615 2.021,0.615 1.813,0.615 false 1.552,3.917 1.833,4.271 0.281,0.354 18 false 1 1.24,1.438 1.521,1.792 0.281,0.354 18 false 2 3.26,5.135 3.542,5.49 0.281,0.354 10 false x4 4.073,5.344 4.354,5.698 0.281,0.354 10 false x4 4.76,5.146 5.042,5.5 0.281,0.354 10 false x9 1.635,0.563 1.917,0.917 0.281,0.354 10 false ●

Procedure Part Name Code
Z101186

Z101188

Z101187

1 NO. 1 ENGINE UNDER COVER ASSEMBLY 51410 - - -
2 CRANK POSITION SENSOR 11401G - - -

● Non-reusable part - -

CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 51410 1.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 11401G 2.REMOVE CRANK POSITION SENSOR

a.
A458730N02
0.99,0.188 1.271,0.542 0.281,0.354 18 true iii 4.531,0.125 4.906,0.417 0.375,0.292 18 true i, ii

i.

Disconnect the crankshaft position sensor connector.


ii.

Using an 8 mm socket wrench, remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.

NOTICE:

If the crankshaft position sensor has been struck or dropped, replace it.



iii.

Remove the O-ring from the crankshaft position sensor.

NOTICE:
·

Make sure to only remove the O-ring with bare hands.

·

When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.

·

If the O-ring groove of the crankshaft position sensor is damaged, replace the crankshaft position sensor with a new one.