Home › Engine / Hybrid System › M15A-FXE (ENGINE CONTROL) › KNOCK SENSOR
RM3700E _51 Engine / Hybrid System _093768 M15A-FXE ENGINE CONTROL _0442042 KNOCK SENSOR A

M15A-FXE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

COMPONENTS (INSTALLATION)
A460414N02
6.208,3.719 6.875,3.885 0.667,0.167 5.313,4 5.313,3.792 false 6.344,0.323 6.677,0.323 false 5.302,2.688 5.302,2.354 false 5.875,3.792 6.208,3.792 false 5.25,4.01 5.531,4.365 0.281,0.354 18 false 1 5.229,2.708 5.51,3.063 0.281,0.354 18 false 2 6.125,0.188 6.406,0.542 0.281,0.354 18 false 3 6.24,3.729 6.948,3.969 0.708,0.24 8 false 20 (204, 15)

Procedure Part Name Code
Z101186

Z101188

Z101187

1 KNOCK SENSOR 89615 (Click here) - -
2 INTAKE MANIFOLD 17111 - - -
3 PERFORM INITIALIZATION - - - -

V100146

N*m (kgf*cm, ft.*lbf): Specified torque - -

CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 89615 1.INSTALL KNOCK SENSOR

a.
A458736C02
0.521,0.104 0.927,0.385 0.406,0.281 18 true i, ii 5.656,0.031 5.917,0.229 0.26,0.198 10 false *a 5.74,0.323 6,0.521 0.26,0.198 10 false *c 5.146,0.375 5.406,0.573 0.26,0.198 10 false *b
*a Top of Vehicle *b 15°
*c 5° - -


i.

Install the knock sensor to the cylinder block sub-assembly with the bolt so that the knock sensor installation position is as shown in the illustration.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:
·

If the knock sensor has been struck or dropped, replace it.

·

Make sure that the knock sensor is in the correct position.




ii.

Connect the knock sensor connector.



Hide 3.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the knock sensor.

Click hereEngine / Hybrid System>M15A-FXE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION