Home › Engine / Hybrid System › M15A-FKS (COOLING) › WATER PUMP
RM3700E _51 Engine / Hybrid System _093771 M15A-FKS COOLING _0442073 WATER PUMP A

M15A-FKS COOLING  WATER PUMP  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
A455821N01
2.844,1.719 3.01,1.719 3.01,1.719 3.177,1.99 false 2.448,2.896 2.583,3.167 2.583,3.167 2.75,3.167 false 1.042,3.323 1.375,3.323 false 3.125,3.021 3.406,3.375 0.281,0.354 18 false 2 0.875,3.188 1.042,3.479 0.167,0.292 18 false 1 1.177,2.677 1.427,2.854 0.25,0.177 10 false x4 2.646,1.667 2.865,1.854 0.219,0.188 10 false ●

Procedure Part Name Code
Z101186

Z101188

Z101187

1 WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 16031 - - -
2 ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING) 16032 (Click here) - -

● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine water pump assembly (water inlet housing) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Cleaning the deposits from the throttle body with motor assembly Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 16031 1.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

Hide 16032 2.REMOVE ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)

a.
A455820N01
2.219,0.156 2.5,0.51 0.281,0.354 18 false i 1.313,1.969 1.594,2.323 0.281,0.354 18 false ii 5.865,1.958 6.146,2.313 0.281,0.354 18 false iii

i.

Using an E8 "TORX" socket wrench, remove the stud bolt.


ii.

Remove the 4 bolts and engine water pump assembly (water inlet housing) from the cylinder block sub-assembly.


iii.

Remove the gasket from the engine water pump assembly (water inlet housing).