| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | WATER INLET WITH THERMOSTAT SUB-ASSEMBLY | 16031 | - | - | - |
| 2 | ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING) | 16032 | - | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine water pump assembly (water inlet housing) removal/installation are shown below.
16031
1.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
16032
2.REMOVE ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)