Home › Engine / Hybrid System › M15A-FKS (LUBRICATION) › OIL PRESSURE AND TEMPERATURE SENSOR
RM3700E _51 Engine / Hybrid System _093774 M15A-FKS LUBRICATION _0442093 OIL PRESSURE AND TEMPERATURE SENSOR A

M15A-FKS LUBRICATION  OIL PRESSURE AND TEMPERATURE SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

COMPONENTS (INSTALLATION)
A459216N02
1.667,4.188 2.5,4.354 0.833,0.167 6.417,0.302 6.75,0.302 false 4.229,4.5 4.563,4.5 false 1.219,4.104 1.219,3.813 false 5.927,0.177 6.573,0.583 0.646,0.406 18 false 2, 3 4.01,4.375 4.365,4.74 0.354,0.365 18 false 4 1.49,4.115 1.844,4.479 0.354,0.365 18 false 1 1.302,4.177 1.552,4.385 0.25,0.208 10 false ★ 1.802,4.198 2.823,4.51 1.021,0.313 8 false 15 (153, 11) 6.167,4.042 6.417,4.25 0.25,0.208 10 false x4

Procedure Part Name Code
Z101186

Z101188

Z101187

1 OIL PRESSURE AND TEMPERATURE SENSOR 89448D (Click here) - -
2 CHECK ENGINE OIL LEVEL - (Click here) - -
3 INSPECT FOR ENGINE OIL LEAK - (Click here) - -
4 ENGINE UNDER COVER RH 51441C - - -

V100146

N*m (kgf*cm, ft.*lbf): Specified torque ★ Precoated part
V100135

Adhesive 1344 - -

PROCEDURE

Hide 89448D 1.INSTALL OIL PRESSURE AND TEMPERATURE SENSOR

a.
A458067N01
2.677,0.177 3.094,0.458 0.417,0.281 18 false i 0.844,2.604 1.26,2.885 0.417,0.281 18 false ii 4.021,2.573 4.438,2.854 0.417,0.281 18 false iii

i.

Apply adhesive to threads of the oil pressure and temperature sensor.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:
·

Do not apply adhesive to the oil inlet port of the oil pressure and temperature sensor.

·

To prevent contamination by foreign matter, install immediately after applying adhesive.




ii.

Using a 24 mm deep socket wrench, install the oil pressure and temperature sensor.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine within 1 hour of installation.



iii.

Connect the oil pressure and temperature sensor connector.



Hide 3.INSPECT FOR ENGINE OIL LEAK

Hide 51441C 4.INSTALL ENGINE UNDER COVER RH