Home › Engine / Hybrid System › M15A-FXE (LUBRICATION) › OIL PRESSURE AND TEMPERATURE SENSOR
RM3700E _51 Engine / Hybrid System _093775 M15A-FXE LUBRICATION _0442099 OIL PRESSURE AND TEMPERATURE SENSOR A

M15A-FXE LUBRICATION  OIL PRESSURE AND TEMPERATURE SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

COMPONENTS (INSTALLATION)
A459230N02
1.604,4.26 2.438,4.427 0.833,0.167 6.438,0.313 6.771,0.313 false 1.375,3.75 1.375,4.167 false 4.552,4.479 4.885,4.479 false 1.417,4.188 1.698,4.542 0.281,0.354 18 false 1 5.958,0.188 6.635,0.615 0.677,0.427 18 false 2, 3 4.354,4.354 4.635,4.708 0.281,0.354 18 false 4 6.531,4.083 6.802,4.281 0.271,0.198 10 false x4 1.24,4.26 1.51,4.458 0.271,0.198 10 false ★ 1.708,4.26 3.052,4.615 1.344,0.354 8 false 15 (153, 11)

Procedure Part Name Code
Z101186

Z101188

Z101187

1 OIL PRESSURE AND TEMPERATURE SENSOR 89448D (Click here) - -
2 CHECK ENGINE OIL LEVEL - (Click here) - -
3 INSPECT FOR ENGINE OIL LEAK - (Click here) - -
4 ENGINE UNDER COVER RH 51441C - - -

V100146

N*m (kgf*cm, ft.*lbf): Specified torque ★ Precoated part
V100135

Adhesive 1344 - -

PROCEDURE

Hide 89448D 1.INSTALL OIL PRESSURE AND TEMPERATURE SENSOR

a.
A458752N01
2.656,0.156 4.031,0.51 1.375,0.354 18 false i 0.865,2.427 2.24,2.781 1.375,0.354 18 false ii 4,2.427 5.375,2.781 1.375,0.354 18 false iii

i.

Apply adhesive to 2 or 3 threads of the oil pressure and temperature sensor.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:
·

Do not apply adhesive to the oil inlet port of the oil pressure and temperature sensor.

·

To prevent contamination by foreign matter, install immediately after applying adhesive.




ii.

Using a 24 mm deep socket wrench, install the oil pressure and temperature sensor.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine within 1 hour of installation.



iii.

Connect the oil pressure and temperature sensor connector.



Hide 3.INSPECT FOR ENGINE OIL LEAK

Hide 51441C 4.INSTALL ENGINE UNDER COVER RH

a.

Remove the 2 screws and separate the front fender liner LH.

Click hereSuspension>FRONT SUSPENSION>FRONT SUSPENSION MEMBER>INSTALLATION