Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER
RM3700E _56 Audio / Visual / Telematics _093686 AUDIO / VIDEO _0442502 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
E452072N01
4.167,1.604 4.167,1.271 false 1.833,2.167 2,2.5 2,2.5 2.167,2.5 false 3.948,1.698 4.104,1.896 0.156,0.198 10 false ● 4.115,1.625 4.396,1.979 0.281,0.354 18 false 2 2.229,2.375 2.51,2.729 0.281,0.354 18 false 1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 DECK TRIM SIDE PANEL ASSEMBLY LH 64740C - - -
2 RADIO SETTING CONDENSER 86011A (Click here) - -

● Non-reusable part - -

PROCEDURE

Hide 64740C 1.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

a.

Use the same procedure as for the RH side.

Click hereVehicle Interior>SEAT BELT>REAR SEAT OUTER BELT ASSEMBLY>REMOVAL


Hide 86011A 2.REMOVE RADIO SETTING CONDENSER

Z101186

NOTICE:

When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.



a.
E452099C02
4.24,1.031 4.469,1.313 0.229,0.281 18 true i 3.458,1.229 3.688,1.51 0.229,0.281 18 true ii 0.948,2.083 1.177,2.365 0.229,0.281 18 true iii 4.26,2.104 4.49,2.385 0.229,0.281 18 true iv
V113147

Remove in this Direction - -


i.

Remove the bolt.


ii.

Disengage the clamp to disconnect the radio setting condenser with wire harness from the vehicle body.


iii.

Using a screwdriver, disengage the claws to remove the terminal cover with wire harness from the radio setting condenser as shown in the illustration.


iv.

Using a screwdriver, bend back and break off the claw as shown in the illustration and remove the terminal cover from the wire harness.

NOTICE:
·

Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

·

Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

·

Check for deformation of the terminal after the wire harness has been removed from the terminal cover.