| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | NO. 2 ANTENNA CORD SUB-ASSEMBLY | 86101J | ( )
|
- | - |
| 2 | ROOF HEADLINING ASSEMBLY | 63310 | - | - | - |
| *A | w/ Digital Audio Broadcasting Antenna | *B | w/o Digital Audio Broadcasting Antenna |
| ● | Non-reusable part | - | - |
86101J
1.INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY
w/ Digital Audio Broadcasting Antenna:
| *a | Marking Tape (A) | *b | Marking Tape (B) |
| *c | Marking Tape (C) | - | - |
|
Marking Tape |
|
Adjustment Area |
Align the marking tape (A) on the No. 2 antenna cord sub-assembly with the protrusion on the front of the roof headlining and wrap new adhesive tape around the No. 2 antenna cord sub-assembly and protrusion of the roof headlining.
Apply the new adhesive tapes as shown in the illustration to secure the No. 2 antenna cord sub-assembly.
Secure the extra length of the No. 2 antenna cord sub-assembly in the adjustment area as shown in the illustration.
Pass the marking tape (B) on the No. 2 antenna cord sub-assembly through the cutout on the rear of the roof headlining.
Align the marking tape (C) on the No. 2 antenna cord sub-assembly with the marking of the roof headlining.
Apply the new adhesive tape as shown in the illustration to secure the No. 2 antenna cord sub-assembly.
Turn the connector contact surface upward and secure it with tape.
Secure the extra length of the No. 2 antenna cord sub-assembly in the adjustment area as shown in the illustration.
w/o Digital Audio Broadcasting Antenna:
| *a | Marking Tape (A) | *b | Marking Tape (B) |
|
Marking Tape |
|
Adjustment Area |
Align the marking tape (A) on the No. 2 antenna cord sub-assembly with the protrusion on the front of the roof headlining and wrap new adhesive tape around the No. 2 antenna cord sub-assembly and protrusion of the roof headlining.
Apply the new adhesive tapes as shown in the illustration to secure the No. 2 antenna cord sub-assembly.
Secure the extra length of the No. 2 antenna cord sub-assembly in the adjustment area as shown in the illustration.
Align the marking tape (B) on the No. 2 antenna cord sub-assembly with the marking of the roof headlining.
Apply the new adhesive tape as shown in the illustration to secure the No. 2 antenna cord sub-assembly.
Turn the connector contact surface upward and secure it with tape.
Secure the extra length of the No. 2 antenna cord sub-assembly in the adjustment area as shown in the illustration.
63310
2.INSTALL ROOF HEADLINING ASSEMBLY