67751
1.REMOVE BACK DOOR TRIM BOARD
86101V
2.REMOVE NO. 6 ANTENNA CORD SUB-ASSEMBLY
for LH Side:
for RH Side:
86101R
3.REMOVE NO. 5 ANTENNA CORD SUB-ASSEMBLY
86101Q
4.REMOVE NO. 4 ANTENNA CORD SUB-ASSEMBLY
Disengage the clamp.
Using a screwdriver with its tip wrapped in protective tape, disengage the claws to separate the grommet.
| *a | Nonwoven Tape | *b | Rope |
|
Remove in this Direction | - | - |
Secure a rope to the No. 4 antenna cord sub-assembly with nonwoven tape as shown in the illustration.
As conduction performance may degrade if adhesive from the nonwoven tape contacts the connecting parts of the connector, cover the connector with a plastic bag or similar before applying the nonwoven tape.
Make sure that the rope is secured with nonwoven tape to prevent the rope from separating from the No. 4 antenna cord sub-assembly when removing it.
Remove the No. 4 antenna cord sub-assembly as shown in the illustration.
The rope will be used when installing the No. 4 antenna cord sub-assembly. Leave the rope inside the back door panel sub-assembly.
This step should not be performed with the back door panel sub-assembly removed from the vehicle.