Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM3700E _56 Audio / Visual / Telematics _093031 PARK ASSIST / MONITORING _0442661 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  U023387  Lost Communication with Side Obstacle Detection Control Module "B" Missing Message  


DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH (A) judges that there is a communication problem with the blind spot monitor sensor LH (B).

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
U023387 Lost Communication with Side Obstacle Detection Control Module "B" Missing Message The blind spot monitor sensor RH (A) cannot receive signals from the blind spot monitor sensor LH (B)
·

Blind spot monitor sensor LH (B)

·

Blind spot monitor sensor RH (A)

·

Harness or connector


Blind Spot Monitor "A" B

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor system is turned on.


HINT:
·

Operating the ignition switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.

·

Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.



PROCEDURE

1.CHECK DTC OUTPUT

Pre-procedure1

a.

Reconnect the cable to the negative (-) auxiliary battery terminal.


b.

Turn the ignition switch off.


c.

Turn the ignition switch to ON.


Procedure1

a.

Check for DTCs.

Body Electrical > Blind Spot Monitor "A" > Trouble Codes
50001 461
Result:
Result Proceed to
U023387 is output A
DTCs are not output B
None of the above conditions are met C



Post-procedure1

a.

None



A

2.REPLACE BLIND SPOT MONITOR SENSOR LH (B)

B

C

2.REPLACE BLIND SPOT MONITOR SENSOR LH (B)

NEXT

3.CLEAR DTC
3.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Blind Spot Monitor "A" > Clear DTCs
50002 461

Result:
Proceed to
NEXT



NEXT

4.CHECK DTC OUTPUT
4.CHECK DTC OUTPUT
a.

Check for DTCs.

Body Electrical > Blind Spot Monitor "A" > Trouble Codes
50001 461

Result:
Result Proceed to
U023387 is output A
DTCs are not output B
None of the above conditions are met C



A

B

END (BLIND SPOT MONITOR SENSOR LH (B) WAS DEFECTIVE)

C