| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blind spot monitor sensor removal/installation are shown below.
1. BSM ECU DATE SAVE
2.REMOVE REAR BUMPER ASSEMBLY
88173
3.REMOVE BLIND SPOT MONITOR COVER LH
88163
4.REMOVE BLIND SPOT MONITOR COVER RH
Use the same procedure for the LH side.
88172
5.REMOVE BLIND SPOT MONITOR SENSOR LH
|
|
88162
6.REMOVE BLIND SPOT MONITOR SENSOR RH
Use the same procedure for the LH side.