This DTC is stored if the parking assist ECU judges that there is an internal malfunction as a result of its self check.
The parking assist ECU stores different types of information during initialization. If the parking assist ECU cannot read the stored information when activated, the parking assist ECU judges that there is an internal malfunction and stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from | Priority |
|---|---|---|---|---|---|---|
| C1614 | ECU Malfunction | ·
Power source malfunction ·
System standby malfunction ·
Main EEPROM malfunction ·
Image ASIC RAM malfunction ·
ASIC status malfunction ·
ECU internal display line malfunction |
Parking assist ECU | ○ | Circumference Monitoring Camera Control Module | A |
When "!" mark is displayed on the parking assist ECU after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
Use the Data List to check if the parking assist ECU status is functioning properly.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Image Processing IC Written Protect Record | A history item indicating that the image processing IC memory was write protected | Unrec/Rec | Unrec: Parking assist ECU normal
Rec: Parking assist ECU abnormal |
- |
| Image Processing IC Initialized Malfunction Record | A history item indicating that the image processing IC memory was not initialized | Unrec/Rec | Unrec: Parking assist ECU normal
Rec: Parking assist ECU abnormal |
- |
| Main EEPROM Access Status | Main EEPROM access status | OK/NG | OK: Parking assist ECU normal
NG: Parking assist ECU abnormal |
- |
| System Power Supply Voltage Malfunction Record | A history item indicating an abnormally generated voltage value from the system power source | Unrec/Rec | Unrec: Parking assist ECU normal
Rec: Parking assist ECU abnormal |
- |
| Main CPU Starting Malfunction Record | A history item indicating that the main CPU did not start | Unrec/Rec | Unrec: Parking assist ECU normal
Rec: Parking assist ECU abnormal |
- |
| Tester Display |
|---|
| Image Processing IC Written Protect Record |
| Image Processing IC Initialized Malfunction Record |
| Main EEPROM Access Status |
| System Power Supply Voltage Malfunction Record |
| Main CPU Starting Malfunction Record |
| Result | Proceed to |
|---|---|
| OK or Unrec is displayed for all items | A |
| NG or Rec is displayed | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Clear the DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| C1614 is output | B |
If DTC C1614 is output, perform the procedure to allow the parking assist ECU to store the vehicle information again.
If DTC C1614 is still output after performing the procedure to make the parking assist ECU store the vehicle information 3 times, replace the parking assist ECU.
If DTC C1614 is output frequently, replace the parking assist ECU even though the DTC is not output when rechecking for DTCs.
A
B