Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SYSTEM › 2020.08–2021.07
RM3700E _56 Audio / Visual / Telematics _093031 PARK ASSIST / MONITORING _0442662 PANORAMIC VIEW MONITOR SYSTEM C

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SYSTEM  C1626  Steering Angle Sensor Failure  


DESCRIPTION

This DTC is stored if the parking assist ECU receives a signal via CAN communication from the steering sensor that indicates an internal malfunction.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
C1626 Steering Angle Sensor Failure A fail flag is transmitted from the steering angle sensor
·

Steering sensor

·

Parking assist ECU


Circumference Monitoring Camera Control Module A

CAUTION / NOTICE / HINT

NOTICE:
·

When "!" mark is displayed on the parking assist ECU after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION

·

The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION



PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

HINT:

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>DTC CHECK / CLEAR


Chassis > Circumference Monitoring Camera Control Module > Clear DTCs
50002 353
Result:
Proceed to
NEXT




NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

HINT:

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>DTC CHECK / CLEAR


Chassis > Circumference Monitoring Camera Control Module > Trouble Codes
50001 353
Result:
Result Proceed to
DTCs are not output A
C1626 is output B




A

B

3.REPLACE STEERING SENSOR
3.REPLACE STEERING SENSOR
a.

Replace the steering sensor with a normally functioning one.

HINT:

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>STEERING ANGLE SENSOR>REMOVAL



Result:
Proceed to
NEXT



NEXT

4.CLEAR DTC
4.CLEAR DTC
a.

Clear the DTCs.

HINT:

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>DTC CHECK / CLEAR


Chassis > Circumference Monitoring Camera Control Module > Clear DTCs
50002 353
Result:
Proceed to
NEXT




NEXT

5.CHECK FOR DTC
5.CHECK FOR DTC
a.

Check for DTCs.

HINT:

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>DTC CHECK / CLEAR


Chassis > Circumference Monitoring Camera Control Module > Trouble Codes
50001 353

Result:
Result Proceed to
DTCs are not output A
C1626 is output B



A

END (STEERING SENSOR WAS DEFECTIVE)

B