This circuit is the power source circuit to operate the parking assist ECU. The parking assist ECU controls the panoramic view monitor system.
When "!" mark is displayed on the radio and display receiver assembly, correct the steering angle neutral point.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
Inspect the fuse for circuits related to this system before performing the following procedure.
Disconnect the O25 parking assist ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(O25)Location & Routingewd_type=routing;type=c;code=O25 Click Connector(O25)Body>Floor Wire>Parking Assist ECUewd_type=component;type=c;code=O25;pinno=2,20 |
||
| O25-2 (GND1) - Body ground | Always | Below 1 Ω |
| O25-20 (GND2) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(O25)Location & Routingewd_type=routing;type=c;code=O25 Click Connector(O25)Body>Floor Wire>Parking Assist ECUewd_type=component;type=c;code=O25;pinno=1,2,19,3,21 |
||
| O25-1 (+B) - O25-2 (GND1) | Ignition switch off | 11 to 14 V |
| O25-19 (+B2) - O25-2 (GND1) | Ignition switch off | 11 to 14 V |
| O25-3 (ACC) - O25-2 (GND1) | Ignition switch ACC | 11 to 14 V |
| Ignition switch off | Below 1 V | |
| O25-21 (IG) - O25-2 (GND1) | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |
| Proceed to |
|---|
| OK |
| NG |
OK
NG