Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › REAR MOTOR GENERATOR CONTROL SYSTEM
RM3700E _51 Engine / Hybrid System _093506 HYBRID / BATTERY CONTROL _0442914 REAR MOTOR GENERATOR CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  REAR MOTOR GENERATOR CONTROL SYSTEM  P0AF211  Drive Motor Inverter Temperature Sensor "B" Circuit Short to Ground  P0AF215  Drive Motor Inverter Temperature Sensor "B" Circuit Short to Battery or Open  


DESCRIPTION

The rear motor generator control ECU (MGR ECU), which is built into in the rear inverter assembly, detects the temperature of the rear motor inverter using the temperature sensor built into the rear inverter assembly. The rear inverter assembly is cooled by a cooling fan. The rear motor generator control ECU uses signals from the rear motor inverter temperature sensor to check the effectiveness of the inverter cooling system. If necessary, the rear motor generator control ECU will limit rear inverter output to help prevent overheating. The rear motor generator control ECU also detects malfunctions in the rear motor inverter temperature sensor and its wiring.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate DTC Output from Priority
P0AF211 Drive Motor Inverter Temperature Sensor "B" Circuit Short to Ground Short to ground detected in rear motor inverter temperature sensor signal circuit
(1 trip detection logic)
Rear hybrid motor control inverter assembly Does not come on Master Warning:
Comes on
Rear Motor Generator A
P0AF215 Drive Motor Inverter Temperature Sensor "B" Circuit Short to Battery or Open Open or short to +B detected in rear motor inverter temperature sensor signal circuit
(1 trip detection logic)
Rear hybrid motor control inverter assembly Does not come on Master Warning:
Comes on
Rear Motor Generator A

Related Data List
DTC No. Data List
P0AF211
P0AF215
Rear Motor Inverter Temperature

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>REAR MOTOR GENERATOR CONTROL SYSTEM>UTILITY


1.

Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

2.

Turn the ignition switch off and wait for 2 minutes or more.

3.

Turn the ignition switch to ON and wait for 5 seconds or more.

4.

Enter the following menus: Powertrain / Rear Motor Generator / Utility / All Readiness.

5.

Check the DTC judgment result.

HINT:
·

If the judgment result shows NORMAL, the system is normal.

·

If the judgment result shows ABNORMAL, the system has a malfunction.

·

If the judgment result shows INCOMPLETE or N/A, perform the normal judgment procedure again.




PROCEDURE

1.REPLACE REAR HYBRID MOTOR CONTROL INVERTER ASSEMBLY

NEXT

COMPLETED