Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › REAR MOTOR GENERATOR CONTROL SYSTEM
RM3700E _51 Engine / Hybrid System _093506 HYBRID / BATTERY CONTROL _0442914 REAR MOTOR GENERATOR CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  REAR MOTOR GENERATOR CONTROL SYSTEM  P0BD111  Drive Motor Inverter Temperature Sensor "C" Circuit Circuit Short to Ground  P0BD115  Drive Motor Inverter Temperature Sensor "C" Circuit Circuit Short to Battery or Open  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate DTC Output from Priority
P0BD111 Drive Motor Inverter Temperature Sensor "C" Circuit Circuit Short to Ground Short to ground detected in rear motor inverter base temperature sensor signal circuit
(1 trip detection logic)
Rear hybrid motor control inverter assembly Does not come on Master Warning:
Comes on
Rear Motor Generator A
P0BD115 Drive Motor Inverter Temperature Sensor "C" Circuit Circuit Short to Battery or Open Open or short to +B detected in rear motor inverter base temperature sensor signal circuit
(1 trip detection logic)
Rear hybrid motor control inverter assembly Does not come on Master Warning:
Comes on
Rear Motor Generator A

Related Data List
DTC No. Data List

*1: Temperature of inverter base plate (frame body) upon which elements are mounted

P0BD111
P0BD115
Rear Motor Base Temperature*1

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>REAR MOTOR GENERATOR CONTROL SYSTEM>UTILITY


1.

Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

2.

Turn the ignition switch off and wait for 2 minutes or more.

3.

Turn the ignition switch to ON and wait for 5 seconds or more.

4.

Enter the following menus: Powertrain / Rear Motor Generator / Utility / All Readiness.

5.

Check the DTC judgment result.

HINT:
·

If the judgment result shows NORMAL, the system is normal.

·

If the judgment result shows ABNORMAL, the system has a malfunction.

·

If the judgment result shows INCOMPLETE or N/A, perform the normal judgment procedure again.




PROCEDURE

1.REPLACE REAR HYBRID MOTOR CONTROL INVERTER ASSEMBLY

NEXT

COMPLETED