The rear inverter contains a three-phase bridge circuit, which consists of 6 power transistors (IGBTs) for the rear motor. The rear inverter converts high-voltage direct current from the HV battery into three-phase alternating current for the rear motor; it also converts three-phase alternating current supplied by the rear motor into direct current for the HV battery. The rear motor generator control ECU controls the actuation of the power transistors (IGBTs). The rear inverter transmits information necessary for control, such as amperage and voltage, to the rear motor generator control ECU.
The rear motor generator control ECU monitors the rear inverter voltage sensor to detect malfunctions.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate | DTC Output from | Priority |
|---|---|---|---|---|---|---|---|
| P0DA316 | Drive Motor "B" Inverter Voltage Sensor "A" Circuit Voltage Below Threshold | Rear inverter voltage (VLR) signal is stuck low:
DTC stored when the VLR sensor signal is excessively low. (1 trip detection logic) |
Rear hybrid motor control inverter assembly | Does not come on | Master Warning:
Comes on |
Rear Motor Generator | A |
| P0DA317 | Drive Motor "B" Inverter Voltage Sensor "A" Circuit Voltage Above Threshold | Rear inverter voltage (VLR) signal is stuck high:
DTC stored when the VLR sensor signal is excessively high. (1 trip detection logic) |
Rear hybrid motor control inverter assembly | Does not come on | Master Warning:
Comes on |
Rear Motor Generator | A |
| P0DA31F | Drive Motor "B" Inverter Voltage Sensor "A" Circuit Intermittent | An excessively high or low voltage signal is output from the VLR sensor when DTC P0C7A17 or P1C5E19 is stored.
(1 trip detection logic) |
Rear hybrid motor control inverter assembly | Does not come on | Master Warning:
Does not come on |
Rear Motor Generator | A |
| DTC No. | Data List |
|---|---|
| P0DA316
P0DA317 P0DA31F |
VLR Voltage |
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>REAR MOTOR GENERATOR CONTROL SYSTEM>UTILITY
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the ignition switch off and wait for 2 minutes or more.
Turn the ignition switch to ON (READY) and wait for 5 seconds or more.
Enter the following menus: Powertrain / Rear Motor Generator / Utility / All Readiness.
Check the DTC judgment result.
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE or N/A, perform the normal judgment procedure again.
| Proceed to |
|---|
| NEXT |
NEXT