Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR (for AWD)
RM3700E _54 Brake _093745 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0443009 REAR SPEED SENSOR(for AWD) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR(for AWD)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
C442421N01
3.469,4 3.885,4 false 1.385,4.365 1.802,4.365 false 3.24,3.854 3.521,4.208 0.281,0.354 18 false 1 2.094,4.208 2.375,4.563 0.281,0.354 18 false 2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 REAR WHEEL - - - -
2 REAR SKID CONTROL SENSOR 89544E (Click here) - -

CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 89544E 2.REMOVE REAR SKID CONTROL SENSOR

a.
C442422N01
0.385,0.042 0.698,0.323 0.313,0.281 18 true i 3.625,0.052 3.896,0.344 0.271,0.292 18 true ii

i.

Using a screwdriver with its tip wrapped with protective tape, Disconnect the rear skid control sensor connector from the rear skid control sensor.

NOTICE:
·

Remove any dirt or foreign matter on and around the rear speed sensor connector before performing this step.

·

Be careful not to damage the rear speed sensor or connector cover.




ii.

Remove the bolt and rear skid control sensor from the rear axle carrier sub-assembly.

NOTICE:
·

Keep the tip of the rear skid control sensor and installation hole free of foreign matter.

·

Do not rotate or apply excessive force to the rear skid control sensor when removing it from the rear axle carrier sub-assembly. Rotating or applying excessive force may result in damage to the rear speed sensor.