|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
After replacing the airbag ECU assembly, make sure to perform ECU configuration.
After performing the ECU configuration procedure, make sure to perform the initialization procedure for when the cable has been disconnected and reconnected to the negative (-) auxiliary battery terminal.
89170A
1.INSTALL AIRBAG ECU ASSEMBLY
| *A | w/ Smart Entry and Start System | *B | w/o Smart Entry and Start System |
| *a | Illumination off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Install the airbag ECU assembly with the 3 bolts.
Temporarily tighten the 2 bolts in the order of (A), (B) and then fully tighten the 3 bolts in the order of (C), (A) and (B).
If the airbag ECU assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
When installing the airbag ECU assembly, make sure that the SRS wiring does not interfere with or is not pinched between other parts.
When the ignition switch is first turned to on (IG) after the airbag ECU assembly has been replaced, make sure that no one is in the vehicle.
Check that there is no looseness in the installed parts of the airbag ECU assembly.
Connect the 2 connectors and push in the lock lever to lock the connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
58510D
2.INSTALL FRONT FLOOR CARPET ASSEMBLY
58910C
3.INSTALL REAR CONSOLE BOX ASSEMBLY
4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>INSTALLATION
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>INSTALLATION
5. UPDATE ECU SECURITY KEY
6. PERFORM DIAGNOSTIC SYSTEM CHECK
8. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
9.PERFORM SYSTEM INITIALIZATION AND CALIBRATION
for Gasoline Model: