Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR (for Front Door) › 2020.08–2021.07
RM3700E _58 Vehicle Interior _093147 SUPPLEMENTAL RESTRAINT SYSTEMS _0443943 SIDE AIRBAG SENSOR(for Front Door) A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR(for Front Door)  INSTALLATION  


CAUTION / NOTICE / HINT

COMPONENTS (INSTALLATION)
B596996N03
4.5,1.083 6.833,2.25 2.333,1.167 3.24,1.844 4.24,2.01 1,0.167 3.198,1.802 4.281,2.052 1.083,0.25 2.969,3.646 2.969,3.313 false 6.49,0.26 6.823,0.26 false 5.667,2.25 5.667,1.083 false 2.76,1.385 2.76,1.052 false 6.417,0.563 6.75,0.563 false 5.052,1.792 5.052,1.458 false 6.25,1.833 6.25,1.5 false 5.479,2.958 5.813,2.958 false 4.573,3.479 4.906,3.479 false 5.75,3.51 6.083,3.51 false 6.073,3.875 6.406,3.875 false 3.583,1.833 3.583,1.5 false 6.448,0.896 6.781,0.896 false 6.208,0.115 6.615,0.458 0.406,0.344 18 false 11 5.677,0.427 6.51,0.781 0.833,0.354 18 false 10, 12 4.958,3.344 5.24,3.698 0.281,0.354 18 false 8 5.01,1.813 5.292,2.167 0.281,0.354 18 false 6 5.854,2.823 6.135,3.177 0.281,0.354 18 false 5 6.188,1.854 6.469,2.208 0.281,0.354 18 false 7 6.698,3.719 6.979,4.073 0.281,0.354 18 false 4 6.375,3.396 6.656,3.75 0.281,0.354 18 false 3 2.906,3.656 3.188,4.01 0.281,0.354 18 false 2 2.75,1.385 3.219,1.74 0.469,0.354 18 false 1 3.5,3.563 3.813,3.76 0.313,0.198 10 false x4 3.094,1.833 3.25,2.031 0.156,0.198 10 false ● 4.583,1.167 4.958,1.406 0.375,0.24 12 false *A 5.75,1.177 6.125,1.417 0.375,0.24 12 false *B 6.271,0.75 6.552,1.104 0.281,0.354 18 false 9 3.292,1.844 4.375,2.01 1.083,0.167 8 false 7.8 (80, 69 in.*lbf)

Procedure Part Name Code
Z101186

Z101188

Z101187

1 SIDE AIRBAG PRESSURE SENSOR 8983A (Click here) - -
2 FRONT DOOR SERVICE HOLE COVER 67831 - - -
3 FRONT DOOR GLASS INNER WEATHERSTRIP 68171B (Click here) - -
4 FRONT DOOR TRIM BOARD SUB-ASSEMBLY 67601 (Click here) - -
5 FRONT DOOR TRIM GARNISH 67655 - - -
6 MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL - - - -
7 POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL - - - -
8 FRONT DOOR LOWER FRAME BRACKET GARNISH 67491A - - -
9 CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL - - - -
10 PERFORM DIAGNOSTIC SYSTEM CHECK - - - (Click here)
11 INSPECT SRS WARNING LIGHT - (Click here) - -
12 INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL - - - (Click here)

*A for Driver Side *B for Front Passenger Side
V111893

Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) ● Non-reusable part

CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the RH side.



PROCEDURE

Hide 8983A 1.INSTALL SIDE AIRBAG PRESSURE SENSOR

a.
B596997C01
1.677,0.802 0.677,0.802 true 0.5,0.708 0.813,0.865 0.313,0.156 10 false *a 4.615,0.104 4.896,0.458 0.281,0.354 18 false ii 0.167,0.094 0.448,0.448 0.281,0.354 18 false i 0.354,1.771 0.729,2.01 0.375,0.24 12 false *A 2.729,1.813 3.104,2.052 0.375,0.24 12 false *B
*A w/ Smart Entry and Start System *B w/o Smart Entry and Start System
*a Illumination off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B593002N01
0.365,0.042 0.646,0.396 0.281,0.354 18 false i 2.729,0.042 3.25,0.396 0.521,0.354 18 false ii, iii 4.906,0.052 5.427,0.406 0.521,0.354 18 false iv

i.

Connect the airbag connector.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



ii.

Engage the claw to hold the side airbag pressure sensor in place.

NOTICE:

If the side airbag pressure sensor has been dropped, replace it with a new one.



iii.

Install a new nut.

Torque:
7.8 N*m (80 kgf*cm, 69 in.*lbf)

NOTICE:
·

When installing the side airbag pressure sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.


·

Do not reuse the nut.




iv.

Check that there is no looseness in the installation parts of the side airbag pressure sensor.



Hide 67831 2.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 68171B 3.INSTALL FRONT DOOR GLASS INNER WEATHERSTRIP

Hide 67601 4.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 67655 5.INSTALL FRONT DOOR TRIM GARNISH

Hide 6.INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

Hide 7.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

Hide 67491A 8.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 9.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 11.INSPECT SRS WARNING LIGHT

Z101186

Click here(Click here)

Hide 12. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART