| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | SEPARATE TYPE FRONT SEATBACK COVER WITH PAD | - | - | - | - |
| 2 | SEPARATE TYPE FRONT SEATBACK COVER | 71073S | - | - | - |
| 3 | FRONT SEATBACK HEATER ASSEMBLY | 87510M | - | - | - |
| *1 | SEPARATE TYPE FRONT SEATBACK PAD | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the occupant detection sensor removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
If a front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad, separate type front seatback cover and front seatback pad with cover with the necessary parts in accordance with the extent of the collision damage.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
71073S
2.REMOVE SEPARATE TYPE FRONT SEAT BACK COVER
87510M
3.REMOVE FRONT SEAT BACK HEATER ASSEMBLY