| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | REAR DRIVE SHAFT ASSEMBLY | 42340B | ( )
|
- | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
Do not apply lubricants to the threaded parts |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 2 | REAR AXLE SHAFT NUT | 42312B | ( )
|
- | - |
| 3 | REAR SKID CONTROL SENSOR | 89544E | ( )
|
||
| 4 | REAR WHEEL | - | - | - | - |
| 5 | CHECK FOR SPEED SENSOR SIGNAL | - | ( )
|
- | - |
| *1 | NO. 2 PARKING BRAKE WIRE ASSEMBLY | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
|
Do not apply lubricants to the threaded parts | - | - |
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
42340B
1.INSTALL REAR DRIVE SHAFT ASSEMBLY
| *a | Matchmark | - | - |
Align the matchmarks and install the rear drive shaft assembly to the rear axle hub and bearing assembly.
Do not damage the rear drive shaft outboard joint boot.
Check that there is no foreign matter on the contact surfaces.
Align the matchmarks on the rear drive shaft assembly and differential side gear shaft sub-assembly.
Do not damage the rear drive shaft inboard joint boot.
Install the 4 nuts and 4 washers.
42312B
2.INSTALL REAR AXLE SHAFT NUT
Clean the threaded parts on the rear drive shaft assembly and a new rear axle shaft nut using non-residue solvent.
Be sure to perform this work even when using a new rear drive shaft assembly.
Keep the threaded parts free of oil and foreign matter.
Keep depressing the brake pedal to prevent the rear drive shaft assembly from rotating.
Using a 30 mm deep socket wrench, temporarily install the rear axle shaft nut.
Using a chisel and hammer, stake the rear axle shaft nut.
4.INSTALL REAR WHEEL
5.CHECK FOR SPEED SENSOR SIGNAL